Rainbow Electronics GM862-QUAD-PY - Manual (Page 194)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 194 of 434
+CNMI - New Message Indications To Terminal Equipment SELINT 2
1
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
• If <dcs> indicates that GSM03.38 default alphabet is used ,
each character of GSM alphabet will be converted into
current TE character set (see +CSCS)
• If <dcs> indicates that 8-bit or UCS2 data coding scheme is
used, each 8-bit octet will be converted into two IRA
character long hexadecimal number (e.g. octet 0x2A will be
converted as two characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited
result code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number; GSM 03.40 TP-Message-
Reference in integer format
<ra> - recipient address, string type, represented in the
currently selected character set (see +CSCS)
<tora> - type of number <ra>
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
2 - if a status report is stored, then the following unsolicited result
code is sent:
+CDSI: <memr>,<index>
where:
<memr> - memory storage where the new message is stored
"SM"
<index> - location on the memory where SMS is stored
<bfr> - buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command
is flushed to the TE when <mode>=1..3 is entered (OK response
shall be given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command
is cleared when <mode>=1..3 is entered.