Rainbow Electronics GM862-QUAD-PY - Manual (Page 277)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 277 of 434
#MONI - Cell Monitor SELINT 2
a. First row reports the identifying name of the ‘columns’
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA
RxQual PLMN<CR><LF>
b. Second row reports a complete set of GSM-related
information for the serving cell:
#MONI: S: <bsic> <lac> <id> <arfcn> <dBm> <C1value>
<C2value> <timadv> <qual> <netname><CR><LF>
c. 3 rd to 8 th rows report a reduced set of GSM-related
information for the cells in the neighbours:
#MONI: N<n> <bsic> <lac> <id> <arfcn> <dBm> <C1value>
<C2value>[<CR><LF>]
where:
<C1value> - C1 reselection parameter
<C2value> - C2 reselection parameter
other parameters as before
AT#MONI=? Test command reports the maximum number of cells, in a neighbour of the
serving cell excluding it, from which we can extract GSM-related
informations, along with the ordinal number of the current selected cell, in
the format:
#MONI: (<MaxCellNo>,<CellSet>)
where:
<MaxCellNo> - maximum number of cells, in a neighbour of the serving cell
and excluding it, from which we can extract GSM-related
informations. This value is always 6.
<CellSet> - the last setting done with command #MONI.
Example Set command selects the cell 0
at#moni=0
OK
Execution command reports GSM-related information for
cell 0
at#moni
#MONI: I WIND BSIC:70 RxQual:0 LAC:55FA Id:1D23 ARFCN:736 PWR:-83dbm TA:1
OK
Set command selects the special request to obtain GSM-
related information from the whole set of seven cells in
the neighbour of the serving cell
at#moni=7
OK
Execution command reports the requested information in