Rainbow Electronics GM862-QUAD-PY - Manual (Page 313)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 313 of 434
context
0
<P_type> - protocol type; a string parameter which specifies the type of
protocol
"IP" - Internet Protocol
<CSD_num> - phone number of the internet service provider
Note: issuing #CGDCONT=0 causes the values for context number 0 to
become undefined.
AT#GSMCONT? Read command returns the current settings for the GSM context, if defined,
in the format:
+CGDCONT: <cid>,<P_type>,<CSD_num>
AT#GSMCONT=? Test command returns the supported range of values for all the parameters.
3.5.7.1.88 Show Address - #CGPADDR
#CGPADDR - Show Address SELINT 2
AT#CGPADDR=
[<cid>[,<cid>
[,…]]] Execution command returns either the IP address for the GSM context (if
specified) and/or a list of PDP addresses for the specified PDP context
identifiers
Parameters:
<cid> - context identifier
0 - specifies the GSM context (see +GSMCONT).
1..5 - numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command).
Note: if no <cid> is specified, the addresses for all defined contexts are
returned.
Note: issuing the command with more than 6 parameters raises an error.
Note: the command returns only one row of information for every specified
<cid>, even if the same <cid> is present more than once.
The command returns a row of information for every specified <cid> whose
context has been already defined. No row is returned for a <cid> whose
context has not been defined yet. Response format is:
#CGPADDR: <cid>,<address>[<CR><LF>
#CGPADDR: <cid>,<address>[…]]
where:
<cid> - context identifier, as before
<address> - its meaning depends on the value of <cid>
a) if <cid> is the (only) GSM context identifier (<cid>=0) it is