Rainbow Electronics GM862-QUAD-PY - Manual (Page 96)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 96 of 434
+CLIR - Calling Line Identification Restriction SELINT 2
Parameter:
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
AT+CLIR? Read command gives the default adjustment for all outgoing calls (<n>) and
also triggers an interrogation of the provision status of the CLIR service
(<m>), where
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
<m> - facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
AT+CLIR=? Test command reports the supported values of parameter <n>.
Reference GSM 07.07
Note This command sets the default behaviour of the device in outgoing calls.
3.5.4.3.10 Call Forwarding Number And Conditions - +CCFC
+CCFC - Call Forwarding Number And Condition SELINT 0 / 1 / 2
AT+CCFC=
<reason>,
<cmd>[,<number>[,
<type>[,<class>
[,,,<time>]]]
Execution command controls the call forwarding supplementary service.
Registration, erasure, activation, deactivation, and status query are
supported.
Parameters:
<reason>
0 - unconditional
1 - mobile busy
2 - no reply
3 - not reachable
4 - all calls (not with query command)
5 - all conditional calls (not with query command)
<cmd>
0 - disable
1 - enable
2 - query status
3 - registration
4 - erasure