Rainbow Electronics GM862-QUAD-PY - Manual (Page 85)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 85 of 434
+COPS - Operator Selection SELINT 0 / 1
Note: issuing AT+COPS<CR> is the same as issuing the Read command.
Note: issuing AT+COPS=<CR> is the same as issuing the command
AT+COPS=0<CR>.
AT+COPS? Read command returns current value of <mode>,<format> and <oper> in
format <format>; if no operator is selected, <format> and <oper> are
omitted
+COPS: <mode>[, <format>, <oper>]
AT+COPS=? Test command returns a list of quadruplets, each representing an operator
present in the network.
The behaviour of Test command depends on the last #COPSMODE setting.
(#COPSMODE=0)
The command outputs as many rows as the number of quadruplets, each of
them in the format:
+COPS: (<stat> ,<oper (in <format>=0)>,””,
<oper (in <format>=2)>)
where
<stat> - operator availability
0 - unknown
1 - available
2 - current
3 - forbidden
(#COPSMODE=1)
The quadruplets in the list are separated by commas:
+COPS: [list of supported (<stat> ,<oper (in <format>=0)>,,
<oper (in <format>=2)> )s][,,(list of supported <mode>s),
(list of supported<format>s)]
where
<stat> - operator availability
0 - unknown
1 - available
2 - current
3 - forbidden
Note: since with this command a network scan is done, this command may
require some seconds before the output is given.
Note: The value of parameter <oper> (in <format>=0) is the same as the