Rainbow Electronics GM862-QUAD-PY - Manual (Page 181)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 181 of 434
+CSDH - Show Text Mode Parameters SELINT 0 / 1
Parameter:
<show>
0 - do not show header values defined in commands +CSCA and +CSMP
(<sca>, <tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda>
or <tooa> in +CMT, +CMGL, +CMGR result codes for SMS-DELIVERs
and SMS-SUBMITs in text mode. For SMS-COMMANDs in +CMGR
result code do not show <pid>, <mn>, <da>, <toda>, <length> or
<cdata>
1 - show the values in result codes
Note: issuing AT+CSDH<CR> is the same as issuing the Read command.
Note: issuing AT+CSDH=<CR> is the same as issuing the command
AT+CSDH=0<CR>.
AT+CSDH? Read command reports the current setting in the format:
+CSDH: <show>
AT+CSDH=? Test command reports the supported range of values for parameter
<show>
Reference GSM 07.05
+CSDH - Show Text Mode Parameters
SELINT 2
AT+CSDH=
[<show>] Set command controls whether detailed header information is shown in text
mode (AT+CMGF=1) result codes.
Parameter:
<show>
0 - do not show header values defined in commands +CSCA and +CSMP
(<sca>, <tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda>
or <tooa> in +CMT, +CMGL, +CMGR result codes for SMS-DELIVERs
and SMS-SUBMITs in text mode. For SMS-COMMANDs in +CMGR
result code do not show <pid>, <mn>, <da>, <toda>, <length> or
<cdata>
1 - show the values in result codes
AT+CSDH? Read command reports the current setting in the format:
+CSDH: <show>
AT+CSDH=? Test command reports the supported range of values for parameter
<show>
Reference GSM 07.05
3.5.5.2.4 Select Cell Broadcast Message Types - +CSCB
+CSCB -Select Cell Broadcast Message Types SELINT 0 / 1
AT+CSCB[= Set command selects which types of Cell Broadcast Messages are to be