Rainbow Electronics GM862-QUAD-PY - Manual (Page 174)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 174 of 434
+CMGF - Message Format SELINT 0 / 1
Parameter:
<mode>
0 - PDU mode, as defined in GSM 3.40 and GSM 3.41 (factory default)
1 - text mode
Note: issuing AT+CMGF<CR> is the same as issuing the Read command.
Note: issuing AT+CMGF=<CR> is the same as issuing the command
AT+CMGF=0<CR>.
AT+CMGF? Read command reports the current value of the parameter <mode>.
AT+CMGF=? Test command reports the supported value of <mode> parameter.
Reference GSM 07.05
+CMGF - Message Format
SELINT 2
AT+CMGF=
[<mode>] Set command selects the format of messages used with send, list, read and
write commands.
Parameter:
<mode>
0 - PDU mode, as defined in GSM 3.40 and GSM 3.41 (factory default)
1 - text mode
AT+CMGF? Read command reports the current value of the parameter <mode>.
AT+CMGF=? Test command reports the supported value of <mode> parameter.
Reference GSM 07.05
3.5.5.2 Message Configuration
3.5.5.2.1 Service Center Address - +CSCA
+CSCA - Service Center Address SELINT 0 / 1
AT+CSCA[=
[<number>
[,<type>]]]
Set command sets the Service Center Address to be used for mobile
originated SMS transmissions.
Parameter:
<number> - SC phone number in the format defined by <type>
<type> - the type of number
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
Note: to use the SM service, is mandatory to set a Service Center Address
at which service requests will be directed.
Note: in Text mode, this setting is used by send and write commands; in