Rainbow Electronics GM862-QUAD-PY - Manual (Page 110)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 110 of 434
+CSSN - SS Notification SELINT 2
<m>.
Reference GSM 07.07
3.5.4.3.17 Closed User Group Supplementary Service Control -
+CCUG
+CCUG - Closed User Group Supplementary Service Control SELINT 0 / 1
AT+CCUG[=
[<n>[,<index>
[,<info>]]]] Set command allows control of the Closed User Group supplementary
service [GSM 02.85].
Parameters:
<n>
0 - disable CUG temporary mode (factory default).
1 - enable CUG temporary mode: it enables to control the CUG information
on the air interface as a default adjustment for all following outgoing
calls.
<index>
0..9 - CUG index
10 - no index (preferential CUG taken from subscriber data) (default)
<info>
0 - no information (default)
1 - suppress Outgoing Access (OA)
2 - suppress preferential CUG
3 - suppress OA and preferential CUG
Note: issuing AT+CCUG<CR> is the same as issuing the Read command.
Note: issuing AT+CCUG=<CR> is the same as issuing the command
AT+CCUG=0<CR>.
AT+CCUG? Read command reports the current value of the parameters
AT+CCUG=? Test command reports the supported range of values for the parameters
<n>, <index>, <info>
Reference GSM 07.07
+CCUG - Closed User Group Supplementary Service Control
SELINT 2
AT+CCUG=
[<n>[,<index>
[,<info>]]] Set command allows control of the Closed User Group supplementary
service [GSM 02.85].
Parameters:
<n>
0 - disable CUG temporary mode (factory default).
1 - enable CUG temporary mode: it enables to control the CUG information
on the air interface as a default adjustment for all following outgoing
calls.