Rainbow Electronics GM862-QUAD-PY User Manual
Page 117
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 117 of 434
+CPIN - Enter PIN
SELINT 0 / 1
%E #SKTSET
+CGMI
$GPSP
%L #SKTOP
+CGMM
$GPSPS
%Q #SKTCT
+CGMR
$GPSR
\Q #SKTSAV
+GMI
$GPSD
\R #SKTRST
+GMM
$GPSSW
\V #ESMTP
+GMR
$GPSAT
#SELINT #EADDR +CGSN
$GPSAV
#CGMI #EUSER +GSN
$GPSAI
#CGMM #EPASSW +CHUP
$GPSAP
#CGMR #SEMAIL +CRLP
$GPSS
#CGSN #EMAILD +CR
$GPSNMUN
#CAP #ESAV +CRC
$GPSACP
#SRS #ERST +CSNS
$GPSWK
#SRP #EMAILMSG
+CREG
$GPSSAV
#STM #CSURV
+COPS
$GPSRST
#PCT #CSURVC
+CLIP
$GPSCON
#SHDN #CSURVU
+CPAS
$GPSPRG
#WAKE #CSURVUC
+CFUN
#QTEMP
All the above commands, but the ones in the grayed cells, can be issued
even if the SIM card is not inserted yet.
All the above commands, but +CSDH and +CNMI, can be issued even if ME
is waiting for phone-To-SIM card password to be given
Reference GSM
07.07
+CPIN - Enter PIN
SELINT 2
AT+CPIN=<pin>
[,<newpin>]
Set command sends to the device a password which is necessary before it
can be operated (SIM PIN, SIM PUK, PH-SIM PIN, etc.).
If the PIN required is SIM PUK or SIM PUK2, the <newpin> is required.
This second pin, <newpin> will replace the old pin in the SIM.
The command may be used to change the SIM PIN by sending it with both
parameters <pin> and <newpin> when PIN request is pending; if no PIN
request is pending the command will return an error code and to change the
PIN the command +CPWD must be used instead.
Parameters:
<pin> - string type value
<newpin> - string type value.
To check the status of the PIN request use the command AT+CPIN?
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command.