Rainbow Electronics GM862-QUAD-PY - Manual (Page 324)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 324 of 434
#SA - Socket Accept SELINT 2
AT#SA=<connId>
[,<connMode>] Execution command accepts an incoming socket connection after an URC
SRING: <connId>
Parameter:
<connId> - socket connection identifier
1..6
<connMode> - Connection mode, as for command #SD.
0 - online mode connection (default)
1 - command mode connection
Note: the SRING URC has to be a consequence of a #SL issue.
AT#SA=? Test command reports the range of values for all the parameters.
3.5.7.3.11 Receive Data In Command Mode - #SRECV
#SRECV - Receive Data In Command Mode SELINT 2
AT#SRECV=
<connId>,
<maxByte> Execution command permits the user to read data arrived through a
connected socket, but buffered and not yet read because the module
entered command mode before reading them; the module is notified of
these data by a SRING URC, whose presentation format depends on the
last #SCFGEXT setting.
Parameters:
<connId> - socket connection identifier
1..6
<maxByte> - max number of bytes to read
1..1500
Note: issuing #SRECV when there’s no buffered data raises an error.
Example SRING URC (<srMode> be 0, <dataMode> be 0) telling data
have just come through connected socket identified by
<connId>=1 and are now buffered
SRING: 1
Read in text format the buffered data
AT#SRECV=1,15
#SRECV: 1,15
stringa di test
OK
SRING URC (<srMode> be 1, <dataMode> be 1) telling 15
bytes data have just come through connected socket
identified by <connId>=2 and are now buffered
SRING: 2,15