Rainbow Electronics GM862-QUAD-PY - Manual (Page 256)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 256 of 434
verify the real temperature bounds for your module.
Extreme Temperature Lower Bound (*) -30°C
Operating Temperature Lower Bound (*) -10°C
Operating Temperature
Operating Temperature Upper Bound (*) +55°C
Extreme Temperature Upper Bound (*) +80°C
(*) Due to temperature measurement uncertainty there is a tolerance
of +/-2°C
3.5.7.1.25 Set General Purpose Output - #SGPO
#SGPO - Set General Purpose Output SELINT 0 / 1
AT#SGPO[=
[<stat>]] Set command sets the value of the general purpose output pin GPIO2.
Parameter:
<stat>
0 - output pin cleared to 0 (Low)
1 - output pin set to 1 (High)
Note: the GPIO2 is an OPEN COLLECTOR output, the command sets the
transistor base level, hence the open collector output is negated:
AT#SGPO=0 sets the open collector output High
AT#SGPO=1 sets the open collector output Low
A pull up resistor is required on pin GPIO2.
Note: issuing AT#SGPO<CR> is the same as issuing the Read command.
Note: issuing AT#SGPO=<CR> is the same as issuing the command
AT#SGPO=0<CR>.
AT#SGPO? Read command reports the #SGPO command setting, hence the opposite
status of the open collector pin in the format:
#SGPO: <stat>.
AT#SGPO=? Test command reports the supported range of values of parameter <stat>.
Note This command is meaningful only for GM862 family
3.5.7.1.26 General Purpose Input - #GGPI
#GGPI - General Purpose Input SELINT 0 / 1
AT#GGPI[=[<dir>]] Set command sets the general purpose input pin GPIO1.
Parameter: