Rainbow Electronics GM862-QUAD-PY - Manual (Page 300)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 300 of 434
#NITZ - Network Timezone SELINT 0 / 1
[,<mode>]]] Date and time information can be sent by the network after GSM
registration or after GPRS attach.
Parameters:
<val>
0 - disables automatic set (factory default)
1 - enables automatic set
<mode>
0 - disables unsolicited message (factory default)
1 - enables unsolicited message; after date and time updating the following
unsolicited indication is sent:
#NITZ: “yy/MM/dd,hh:mm:ss”
where:
yy - year
MM - month (in digits)
dd - day
hh - hour
mm - minute
ss - second
Note: issuing AT#NITZ<CR> is the same as issuing the Read command.
Note: issuing AT#NITZ=<CR> is the same as issuing the command
AT#NITZ=0<CR>.
AT#NITZ? Read command reports whether automatic date/time updating is currently
enabled or not, and whether Network Timezone unsolicited indication is
enabled or not, in the format:
#NITZ: <val>,<mode>
AT#NITZ=? Test command returns supported values of parameters <val> and <mode>.
#NITZ - Network Timezone
SELINT 2
AT#NITZ=
[<val>
[,<mode>]] Set command enables/disables (a) automatic date/time updating, (b) Full
Network Name applying and (c) #NITZ URC; moreover it permits to change
the #NITZ URC format.
Date and time information can be sent by the network after GSM
registration or after GPRS attach.
Parameters:
<val>
0 - disables (a) automatic data/time updating, (b) Full Network Name
applying and (c) #NITZ URC; moreover it sets the #NITZ URC ‘basic’
format (see <datetime> below) (factory default)
1..7 - as a sum of:
1 - enables automatic date/time updating