44 serving cell information - #servinfo – Rainbow Electronics GM862-QUAD-PY User Manual
Page 278
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 278 of 434
#MONI - Cell Monitor
SELINT 2
table-like format
at#moni
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN
#MONI: S 70 55FA 1D23 736 -83dbm 19 33 1 0 I WIND
#MONI: N1 75 55FA 1297 983 -78dbm 26 20
#MONI: N2 72 55FA 1289 976 -82dbm 22 16
#MONI: N3 70 55FA 1D15 749 -92dbm 10 18
#MONI: N4 72 55FA 1D0D 751 -92dbm 10 18
#MONI: N5 75 55FA 1296 978 -95dbm 9 3
#MONI: N6 70 55FA 1D77 756 -99dbm 3 11
OK
Note
The refresh time of the measures is preset to 3 sec.
The timing advance value is meaningful only during calls or GPRS transfers
active.
3.5.7.1.44 Serving Cell Information - #SERVINFO
#SERVINFO - Serving Cell Information
SELINT 0 / 1
AT#SERVINFO
Execution command reports information about serving cell, in the format:
#SERVINFO: <B-ARFCN>,<dBM>,<NetNameAsc>,<NetCode>,
,<BSIC>,<LAC>,<TA>,<GPRS>[,[<PB-ARFCN>],[<NOM>],
<RAC>,[PAT]]
where:
<B-ARFCN> - BCCH ARFCN of the serving cell
<dBM> - received signal strength in dBm
<NetNameAsc> - operator name, quoted string type
<NetCode> - country code and operator code, hexadecimal
representation
<BSIC> - Base Station Identification Code
<LAC> - Localization Area Code
<TA> - Time Advance: it’s available only if a GSM or GPRS is running
<GPRS> - GPRS supported in the cell
0 - not supported
1 - supported
The following information will be present only if GPRS is supported in the
cell
<PB-ARFCN> - PBCCH ARFCN of the serving cell; it’ll be printed only if
PBCCH is supported by the cell, otherwise the label “hopping” will
be printed
<NOM> - Network Operation Mode
..”I”
“II”
..”III”
<RAC> - Routing Area ColoUr Code
<PAT> - Priority Access Threshold