Rainbow Electronics GM862-QUAD-PY - Manual (Page 310)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 310 of 434
<urcmode> - URC presentation mode. It has meaning only if <mod> is 1.
0 - it disables the presentation of the antenna detection URC
1 - it enables the presentation of the antenna detection URC, whenever
the antenna detection algorithm detects a change in the antenna status;
the unsolicited message is in the format:
#GSMAD: <presence>
where:
<presence> is as before
<interval> - duration in seconds of the interval between two consecutive
antenna detection algorithm runs (default is 120). It has
meaning only if <mod> is 1.
..1..3600 - seconds
<detGPIO> - defines which GPIO shall be used as input by the Antenna
Detection algorithm (default 13). For the <detGPIO> actual
range check the “Hardware User Guide”
<repGPIO> - defines which GPIO shall be used by the Antenna Detection
algorithm to report antenna condition. It has meaning only if
<mod> is 1. For the <repGPIO> actual range check the
“Hardware User Guide”
Note: the URC presentation mode <urcmode> is related to the current
multiplexed instance only (see +cmux); last <urcmode> settings are saved
for every instance as extended profile parameters, thus it is possible to
restore them either if the multiplexer control channel is released and set up,
back and forth.
Note: GPIO is set to LOW when antenna is connected. Set to HIGH
otherwise
Note: #GSMAD parameters, excluding <urcmode>, are saved in NVM.
AT#GSMAD? Read command returns the current parameter settings for #GSMAD
command in the format:
#GSMAD: <mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>
AT#GSMAD=? Test command reports the supported range of values for parameters
<mod>, <urcmode>, <interval>, <detGPIO> and <repGPIO>.
3.5.7.1.83 SIM Detection Mode - #SIMDET
#SIMDET - SIM Detection Mode SELINT 2
AT#SIMDET=
<mode> Set command specifies the SIM Detection mode
Parameter: