Rainbow Electronics GM862-QUAD-PY - Manual (Page 293)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 293 of 434
#HSMICG - Handset Microphone Gain SELINT 2
Parameter:
<level>: handset microphone input gain
0..7 - handset microphone gain (+6dB/step)
AT#HSMICG? Read command returns the current handset microphone input gain, in the
format:
#HSMICG: <level>
AT#HSMICG=? Test command returns the supported range of values of parameter <level>.
3.5.7.1.58 Set Headset Sidetone - #SHFSD
#SHFSD - Set Headset Sidetone SELINT 0 / 1
AT#SHFSD[=
[<mode>]] Set command enables/disables the sidetone on headset audio output.
Parameter:
<mode>
0 - disables the headset sidetone (factory default)
1 - enables the headset sidetone.
Note: This setting returns to default after power off.
Note: issuing AT#SHFSD<CR> is the same as issuing the Read command.
Note: issuing AT#SHFSD=<CR> is the same as issuing the command
AT#SHFSD=0<CR>.
AT#SHFSD? Read command reports whether the headset sidetone is currently enabled
or not, in the format:
#SHFSD: <mode>
AT#SHFSD=? Test command returns the supported range of values of parameter
<mode>.
#SHFSD - Set Headset Sidetone
SELINT 2
AT#SHFSD=
[<mode>] Set command enables/disables the sidetone on headset audio output.
Parameter:
<mode>
0 - disables the headset sidetone (factory default)
1 - enables the headset sidetone.
Note: This setting returns to default after power off.
AT#SHFSD? Read command reports whether the headset sidetone is currently enabled
or not, in the format:
#SHFSD: <mode>