Rainbow Electronics GM862-QUAD-PY - Manual (Page 276)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 276 of 434
#MONI - Cell Monitor SELINT 2
Set command sets one cell out of seven, in a neighbour of the serving cell
including it, from which extract GSM-related information.
Parameter:
<number>
0..6 - it is the ordinal number of the cell, in a neighbour of the serving cell
(default 0, serving cell).
7 - it is a special request to obtain GSM-related information from the whole
set of seven cells in the neighbour of the serving cell.
Execution command (AT#MONI<CR>) reports GSM-related information for
selected cell and dedicated channel (if exists).
2. If the last setting done by #MONI is in the range [0..6], the output
format is as follows:
d) When extracting data for the serving cell and the network name is
known the format is:
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac>
Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
e) When the network name is unknown, the format is:
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac>
Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
f) When extracting data for an adjacent cell, the format is:
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn>
PWR:<dBm> dBm
where:
<netname> - name of network operator
<cc> - country code
<nc> - network operator code
<n> - progressive number of adjacent cell
<bsic> - base station identification code
<qual> - quality of reception
0..7
<lac> - localization area code
<id> - cell identifier
<arfcn> - assigned radio channel
<dBm> - received signal strength in dBm
<timadv> - timing advance
Note: TA: <timadv> is reported only for the serving cell.
3. If the last setting done by #MONI is 7, the execution command
produces a table-like formatted output, as follows: