Rainbow Electronics GM862-QUAD-PY - Manual (Page 93)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 93 of 434
+CLIP - Calling Line Identification Presentation SELINT 0 / 1
<CLI_validity>
0 - CLI valid
1 - CLI has been withheld by the originator.
2 - CLI is not available due to interworking problems or limitation or
originating network.
Note: in the +CLIP: response they are currently not reported either the
subaddress information (it’s always “” after the 2
nd comma) and the
subaddress type information (it’s always 128 after the 3 rd comma)
Note: issuing AT+CLIP<CR> is the same as issuing the Read command.
Note: issuing AT+CLIP=<CR> is the same as issuing the command
AT+CLIP=0<CR>.
AT+CLIP? Read command returns the presentation status of the CLI in the format:
+CLIP: <n>,<m>
where:
<n>
0 - CLI presentation disabled
1 - CLI presentation enabled
<m> - status of the CLIP service on the GSM network
0 - CLIP not provisioned
1 - CLIP provisioned
2 - unknown (e.g. no network is present )
Note: This command issues a status request to the network, hence it may
take a few seconds to give the answer due to the time needed to exchange
data with it.
AT+CLIP=? Test command returns the supported values of the parameter <n>
Reference GSM 07.07
Note The command changes only the report behaviour of the device, it does not
change CLI supplementary service setting on the network.
+CLIP - Calling Line Identification Presentation
SELINT 2
AT+CLIP=[<n>] Set command enables/disables the presentation of the CLI (Calling Line
Identity) at the TE. This command refers to the GSM supplementary service
CLIP (Calling Line Identification Presentation) that enables a called
subscriber to get the CLI of the calling party when receiving a mobile
terminated call.
Parameters:
<n>