Rainbow Electronics GM862-QUAD-PY - Manual (Page 111)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 111 of 434
+CCUG - Closed User Group Supplementary Service Control SELINT 2
<index>
0..9 - CUG index
10 - no index (preferential CUG taken from subscriber data) (default)
<info>
0 - no information (default)
1 - suppress Outgoing Access (OA)
2 - suppress preferential CUG
3 - suppress OA and preferential CUG
AT+CCUG? Read command reports the current value of the parameters
AT+CCUG=? Test command returns the OK result code
Reference GSM 07.07
3.5.4.3.18 Preferred Operator List - +CPOL
+CPOL - Preferred Operator List SELINT 2
AT+CPOL=
[<index>][,<format>
[,<oper>]]
Execution command writes an entry in the SIM list of preferred operators.
Parameters:
<index> - integer type; the order number of operator in the SIM preferred
operator list
1..n
<format>
2 - numeric <oper>
<oper> - string type
Note: if <index> is given but <oper> is left out, entry is deleted. If <oper> is
given but <index> is left out, <oper> is put in the next free location. If only
<format> is given, the format of the <oper> in the read command is
changed.
AT+CPOL? Read command returns all used entries from the SIM list of preferred
operators.
AT+CPOL=? Test command returns the whole <index> range supported by the SIM and
the range for the parameter <format>
Reference GSM 07.07
3.5.4.4 Mobile Equipment Control
3.5.4.4.1 Phone Activity Status - +CPAS
+CPAS - Phone Activity Status SELINT 0 / 1
AT+CPAS Execution command reports the device status in the form:
+CPAS: <pas>
Where: