Rainbow Electronics GM862-QUAD-PY - Manual (Page 249)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 249 of 434
#TSVOL – Tone Classes Volume SELINT 2
#TSVOL: 64,1,5
OK
3.5.7.1.16 Select Registration Operation Mode - #REGMODE
#REGMODE – Select Registration Operation Mode SELINT 2
AT#REGMODE=
<mode> There are situations in which the presentation of the URCs controlled by
either +CREG and +CGREG are slightly different from ETSI specifications.
We identified this behaviour and decided to maintain it as default for
backward compatibility issues, while we’re offering a more formal
‘Enhanced Operation Mode’ through #REGMODE.
Set command sets the operation mode of registration status commands.
Parameter:
<mode> - operation mode of registration status commands
0 - basic operation mode (default)
1 - enhanced operation mode
AT#REGMODE? Read command returns the current registration operation mode.
AT#REGMODE=? Test command reports the available range of values for parameter <mode>
Note The affected commands are +CREG and +CGREG
3.5.7.1.17 SMS Commands Operation Mode - #SMSMODE
#SMSMODE - SMS Commands Operation Mode SELINT 2
AT#SMSMODE=
<mode> Set command enables/disables the improved SMS commands operation
mode
Parameter:
<mode> - SMS commands operation mode
0 - disable improved SMS commands operation mode (default)
1 - enable improved SMS commands operation mode
AT#SMSMODE? Read command reports whether the improved SMS commands operation
mode is enabled or not, in the format:
#SMSMODE: <mode>
(<mode> described above)
AT#SMSMODE=? Test command reports the supported range of values for parameter
<mode>
Note The SMS commands affected by #SMSMODE are: +CPMS, +CNMI,
+CMGS, +CMGW, +CMGL, +CMGR, +CMGD, +CSMP