Rainbow Electronics GM862-QUAD-PY - Manual (Page 36)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 36 of 434
3.5.3.1.6 Store Current Configuration - &W
&W - Store Current Configuration SELINT 0 / 1 / 2
AT&W[<n>] Execution command stores on profile <n> the complete configuration of the
device.
Parameter:
<n>
0..1 - profile
Note: if parameter is omitted, the command has the same behaviour of
AT&W0.
3.5.3.1.7 Store Telephone Number In The Module Internal Phonebook - &Z
&Z - Store Telephone Number In The Wireless Module Internal Phonebook SELINT 0 / 1 / 2
AT&Z<n>=<nr>
Execution command stores in the record <n> the telephone number <nr>.
The records cannot be overwritten, they must be cleared before rewriting.
Parameters:
<n> - phonebook record
<nr> - telephone number (string type)
Note: the wireless module has a built in non volatile memory in which 10
telephone numbers of a maximum 24 digits can be stored
Note: to delete the record <n> the command AT&Z<n>=<CR> must be
issued.
Note: the records in the module memory can be viewed with the command
&N, while the telephone number stored in the record n can be dialed by
giving the command ATDS=<n>.
3.5.3.1.8 Display Internal Phonebook Stored Numbers - &N
&N - Display Internal Phonebook Stored Numbers SELINT 0 / 1 / 2
AT&N[<n>] Execution command returns the telephone number stored at the <n>
position in the internal memory.
Parameter:
<n> - phonebook record number
Note: if parameter <n> is omitted then all the internal records are shown.
3.5.3.1.9 Manufacturer Identification - +GMI
+GMI - Manufacturer Identification SELINT 0 / 1 / 2