Rainbow Electronics GM862-QUAD-PY - Manual (Page 146)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 146 of 434
+CPUC - Price Per Unit And Currency Table
SELINT 2
AT+CPUC=
<currency>,
<ppu>[,<pwd>] Set command sets the values of Advice of Charge related Price per Unit
and Currency Table stored in SIM (PUCT). The PUCT information can be
used to convert the home units (as used in commands +CAOC, +CACM
and +CAMM) into currency units.
Parameters:
<currency> - string type; three-character currency code (e.g. “LIT”, “L. “,
“USD”, “DEM” etc..); used character set should be the one selected
with command +CSCS.
<ppu> - price per unit, string type (dot is used as decimal separator) e.g.
“1989.27”
<pwd> - SIM PIN2; if PIN2 has been already input once after startup, it is
required no more
AT+CPUC? Read command reports the current values of <currency> and <ppu>
parameters in the format:
+CACM : <currency>,<ppu>
AT+CPUC=? Test command returns the OK result code
Reference GSM 07.07
3.5.4.4.21 Available AT Commands - +CLAC
+CLAC - Available AT Commands SELINT 2
AT+CLAC Execution command causes the ME to return the AT commands that are
available for the user, in the following format:
<AT cmd1>[<CR><LF><AT cmd2>[…]]
where:
<AT cmdn> - defines the AT command including the prefix AT
AT+CLAC=? Test command returns the OK result code
Reference GSM 07.07
3.5.4.4.22 Delete Alarm - +CALD
+CALD - Delete Alarm SELINT 2
AT+CALD=<n> Execution command deletes an alarm in the ME
Parameter:
<n> - alarm index
0
AT+CALD=? Test command reports the range of supported values for <n> parameter.
Reference 3G TS 27.007