Rainbow Electronics GM862-QUAD-PY - Manual (Page 336)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 336 of 434
#DSTO - Data Sending Time-Out SELINT 0 / 1
Note: this time-out applies to data whose size is less than packet size and
whose sending would have been delayed for an undefined time until new
data to be sent had been received and full packet size reached.
Note: issuing AT#DSTO<CR> is the same as issuing the Read command.
Note: issuing AT#DSTO=<CR> is the same as issuing the command
AT#DSTO=0<CR>.
AT#DSTO? Read command reports the current data sending time-out value.
AT#DSTO=? Test command returns the allowed values for the parameter <tout>.
Example AT#DSTO=10 ->1 sec. time-out
OK
AT#DSTO?
#DSTO: 10
OK
#DSTO -Data Sending Time-Out
SELINT 2
AT#DSTO=
[<tout>] Set command sets the maximum time that the module awaits before
sending anyway a packet whose size is less than the default one.
Parameter:
<tout> - packet sending time-out in 100ms units (factory default is 50)
0 - no time-out, wait forever for packets to be completed before send.
1..255 hundreds of ms
Note: In order to avoid low performance issues, it is suggested to set the
data sending time-out to a value greater than 5.
Note: this time-out applies to data whose size is less than packet size and
whose sending would have been delayed for an undefined time until new
data to be sent had been received and full packet size reached.
Note: this command is not allowed for sockets associated to a GSM context
(see #SCFG).
AT#DSTO? Read command reports the current data sending time-out value.
AT#DSTO=? Test command returns the allowed values for the parameter <tout>.
Example AT#DSTO=10 ->1 sec. time-out
OK
AT#DSTO?
#DSTO: 10
OK
3.5.7.5.5 Socket Inactivity Time-Out - #SKTTO
#SKTTO - Socket Inactivity Time-Out SELINT 0 / 1