Yaskawa iQpump Controller Programming Manual - Manual (Page 112)

112 YASKAWA TM.iQp.07 iQpump Controller Programming Manual
72E
Extended Pump Status Word 1
Bit Description
0 Sleep Active
1 Accum. Level Maximum Reached
2 During Run 2
3 Lube Pump Active
4 High Flow Active
5 Low Water Level Active (Digital Input)
6 High Water Level Active (Digital Input)
7 Sleep Boost Active
8 Thrust Bearing Decel Active
9 Thrust Bearing Accel Active
10 Motor 2 Alternate Enabled (P4-14 > 0 and P1-01 = 0)
11 Alternate Motor 2 Selected
12 Alternate Motor Change Pending
13 Dual Zone PI Control Enabled
14 Dual Zone: Zone 1 Active (both Zone 1 and Zone 2 for Zone 3)
15 Dual Zone: Zone 2 Active (both Zone 1 and Zone 2 for Zone 3)
72F
Extended Pump Status Word 1
Bit Description
0 Timer Run Active (On / Off Control)
1 Low City Pressure Input Active (after time delay)
2 Water Level Control Active
3 Low Water Level Detected (Water Level Control Mode, Auto-Mode Run Only
4 Pre-charge Freq. 1 Active
5 Pre-charge Freq. 2 Active
6 ~ 15 -- NOT USED--
730 Anti-Jam / De-Scale: Cycle Count
731 Utility Delay Timer (1 = 0.1 min)
732 Fault Restart Timer (1 = 0.1 s)
733 Active Alternate Timer (Two Motor Alternation Function) (1 = 0.1 hr)
734 Active On Timer (Run / Stop Mode) (1 = 0.1 min)
735 Active Off Timer (Run / Stop Mode) (1 = 0.1 min)
736 Control Cycles (Run / Stop Mode)
737 De-Scale Run Timer (1 = 0.1 hr)
750 Pump System Array Index (for Writing) (master only)
751 Pump System Array Index (for Reading / Verification) (master only)
752 Pump System Array drive_status (master only)
753 Pump System Array pump_status (master only)
754 Pump System Array pump_runtime (master only)
755 Pump System Array pump _feedback_o (master only)
756 Pump System Array pump_control (master only)
757 Pump System Array pump_control2 (master only)
758 Pump System Array pump_feedback_x (master only)
759 Pump System Array pump_running (master only)
75A Pump System Array pump_available (master only)
75B Pump System Array Index (for Writing) (master only)
75C Pump System Array Index (for Reading) (master only)
75D Pump System Array address (master only)
75E Pump Queue Array p_stats (master only)
75F Pump Queue Array queue_no (master only)
760 Network Status Flags net_status (master only)
761 Network Status Flags net_status2 (master only)
762 Communication Register i_drive_status
763 Communication Register i_pump_status
764 Communication Register i_pump_runtime
Register Hex Description