Yaskawa iQpump Controller Programming Manual - Manual (Page 245)

YASKAWA TM.iQp.07 iQpump Controller Programming Manual 245
Table 117 Auto Mode vs. Network RUN Cmd Display Text
Network State Display
Drive is not able to accept commands form the iQpump MEMOBUS /
Modbus Network because the drive is not in Auto Mode Run.
Drive is in Auto Mode and waiting for a run command from the iQpump
MEMOBUS / Modbus Network.
Drive is in Auto Mode, Lead operation and is currently regulating the system
using PI control.
Drive is in Auto Mode, Lag operation and is currently regulating the system
using PI control.
Drive is in Auto Mode, Lag operation and is holding the speed at the time it
made the switch from being a lead drive to a lag. Speed is held until P9-07
time expires. U1-01 will display Frequency instead of System Units.
Drive is in Auto Mode, Lag operation and is running at the speed set in P9-06.
U1-01 will display Frequency instead of System Units.