INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 149)

3 - 55
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
3.7.1.5 TUNE STATUS Icon
This icon provides information about the state of the HAPSITE’s tune. If the TUNE
icon is green, the tune status is good. The TUNE icon will turn yellow when a tune
check will be run in the near future. The icon will turn blue when the HAPSITE is in
the process of tuning. If the TUNE icon is red, the AutoTune has failed. When
AutoTune fails, an AutoTune will need to be run again or the HAPSITE Smart PLUS
should be manually tuned. See
Section Chapter 7, Tune, on page 7-1 .
To run a tune check, press the RUN AUTOTUNE button, which is shown at the
bottom of the screen. This button allows for an AutoTune to be run from the front
panel. The button will be grayed out when a tune is in progress. See
Figure 3-91 .
Figure 3-91 Run AutoTune
Touching the TUNE STATUS icon will also display the file name of the last tune
report, the time the instrument tuned, and the date the instrument tuned. It will also
show a countdown of the time to the next tune check.
The pressure of the MS at the last tune check will be displayed. If a method is not
running and the last tune pressure was within range, an Acceptable message will
be displayed. If a method is being run or manual tune is open, the current MS
pressure will also appear.