INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 487)

15 - 13
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
15.7.1 Attaching the HAPSITE to the Service Module using the
Plus IQ Software
Be sure to connect the HAPSITE to the Laptop before continuing. Refer to section
2.4.6, Connect Laptop (if desired), on page 2-10 , if a connection is needed.
1 Make sure that the HAPSITE does not heat. On the HAPSITE screen, touch
STOP PREPARE or using the arrow keys, highlight STOP PREPARE and
push OK SEL. See
Figure 15-13 .
Figure 15-13 Stop Prepare Button
2 In Plus IQ, left-click on the desired HAPSITE sensor, then double-click the
Service Module icon, shown in
Figure 15-14 .
Figure 15-14 Service Module Icon in System Setup View, after Selecting HAPSITE Sensor