INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 375)

11 - 15
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Figure 11-12 Method Editor Inlet Page for GC/MS Full Scan
The only difference on the Inlet page between an Analyze (GC/MS) Full Scan
method and an Analyze (GC/MS) SIM method is that the Run Time parameter entry
is replaced with a table showing the SIM Sets as programmed on the SIM page
(refer to
section 11.3.2, SIM Method, on page 11-7 ). This difference is shown in
Figure 11-13 .