2 event log files, 3 data files – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 349
10 - 3
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
10.1.2 Event Log Files
Event Log Files are created automatically by the system to record system state
information (such as heating, valve changes, etc.) for future reference. These files
are created daily when running the HAPSITE using the Plus IQ software. These
files are saved on the Laptop. Refer to
section 10.2, Saving Files to the Laptop, on
, for more information.
10.1.3 Data Files
Data files are automatically saved to the HAPSITE hard drive, in a data directory
under a folder named the same as the Method used to run the analysis. For
example, in the case where a Method named Method01 was used to run the
analysis, the folder where files are saved for that method would be data\Method01\.
The default naming convention for these files is to use the method name with an
underscore and 3 digits added to the end. The first file would start with _001. This
file name would then be incremented each time a new analysis is performed. The
name may be modified by selecting the Method Editor - Data page, shown in
Figure 10-4
.