Caution – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 215
Advertising
5 - 9
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
4
Click the desired method and then click OK. See Figure 5-12
Figure 5-12 Selecting the Method
5
The software will check the pressure in the gas canisters, heat up all necessary
components, run an AutoTune (if required), and make tune adjustments as
necessary. A Concentrator Cleanout will also be run if needed. The process
may take up to 20 minutes.
6
When it is done heating, a prompt will appear to indicate the HAPSITE is ready
to run a sample. Click RUN.
CAUTION
Do not touch the sample with the Probe. Do not place the
sample Probe in liquids while sampling.
Advertising