INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 64)

2 - 26
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
NOTE: Black latches can be adjusted with the thumb screw to ensure proper
tension.
Figure 2-41 HAPSITE Attached to Service Module using Service Module Latches -
Left Side View
Continue by following the instructions in section 15.6, Starting Up HAPSITE on the
Service Module, on page 15-11 .
CAUTION
Never attempt to move the Service Module when the
turbo pump is spinning. The Turbo Pump must be at 0 Hz
before moving or detaching the HAPSITE. Damage can
result if the HAPSITE is not properly detached.
2.8.3 Detaching the HAPSITE from the Service Module
Carefully follow the procedures starting with section 15.8, Detaching the HAPSITE,
on page 15-17 to detach the HAPSITE from the Service Module.