INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 547)

16 - 49
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Figure 16-56 Holding Down the Needle while Tightening the Nuts (So Ferrules Seat Properly)
9 Now that the needle is securely in place, replace the cover and two screws.
Tighten both screws using the Phillips screwdriver.
10 The HSS is now equipped with a new needle and is ready to operate.
16.10 Battery Charger Maintenance and Troubleshooting
WARNING - Risk Of Electric Shock
Do not attempt to open the case of the Battery Charger.
There are no user-serviceable parts inside.
16.10.1 Cleaning The Battery Charger
WARNING - Risk Of Electric Shock
Disconnect the power cord and remove any batteries
from the Battery Charger before proceeding.
Clean the surfaces with a damp cloth or sponge and (if desired) a mild household
cleaner. Do not use excess water or allow water into the receptacles.
Be sure the cooling slots at the back are clean, as well as the holes in the aluminum
base-plate. Be sure the Battery Charger is dry before applying power.