INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 295
Advertising
8 - 19
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
7
Select Use the following IP address and enter the IP address of the
HAPSITE, (refer to
on page 8-22), with the number 128 added to the
third number of the first line of the IP address. This is necessary in order for the
system to configure communications properly. Example: 10.210.4.62 becomes
10.210.132.62. Press OK.
NOTE: If configuring the HAPSITE for a wireless configuration, change the second
number, 210, to 209.
Figure 8-27 Entering IP Address
8
Press OK in the Internet Protocol Window to close the window.
9
Communication between the HAPSITE and the Laptop is now established as
indicated by the HAPSITE Sensor in the Plus IQ System Setup Window.
Figure 8-28 Active HAPSITE Sensor Icon
Advertising