9 situprobe – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 65
2 - 27
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
2.9 SituProbe
Use the following procedure to set up the SituProbe. For more SituProbe
information, see
1
After verifying that the battery in the HAPSITE is charged, disconnect the AC
to DC HAPSITE Adapter power supply.
2
Remove the Probe.
3
Using a Y-Cable Power Splitter, connect the single connector end of the cable
to the AC to DC HAPSITE Adapter. Connect one of the split ends of the cable
to the left side of the HAPSITE and the other to the back of the SituProbe
accessory (IPN 932-220-G1). See
and
Figure 2-42 Y- Cable for SituProbe
Figure 2-43 Plugging Y-Cable Into HAPSITE
Figure 2-44 Plugging Y-Cable Into SituProbe
4
Properly align the labels on the foam insulation and Transfer Line. The end of
the insulation labeled in yellow THIS END TO HAPSITE should coincide with
the end of the Transfer Line labeled in yellow THIS END TO HAPSITE. See
Figure 2-23
.