2 survey mode – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 208
5 - 2
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
5.2 Survey Mode
The Survey Mode is used for quick analysis and tentative results. The run period is
determined by the user, but it is generally two minutes long.
Overview:
Sample the air away from the area of concern for one minute to determine the
background composition.
CAUTION
Do not touch the sample with the probe. Do not allow
liquids to enter the Probe.
When the background has been determined, sample directly over the area of
concern to see what additional chemicals are present.
NOTE: See
, for additional information on the Survey method.
1
Open the Plus IQ software by double-clicking on the icon shown
in
Figure 5-1
.
Figure 5-1 Plus IQ Icon
2
When powered on or taken out of Extended Standby (refer to
or
), the HAPSITE will automatically start
preparing the start up method. If this method is not the desired method, see
Section 5.3, Selecting a New Method, on page 5-7
.
3
The following message will appear on the Laptop during the power on
sequence. See
Figure 5-2
.
Figure 5-2 NEG Full Power