INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 296
8 - 20
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
8.6.3 Establishing Communication with the Service Module
Service Module communications will be established automatically if a COM port
has been selected. Plus IQ has been set up with COM1 communications, so Plus
IQ will automatically recognize and communicate when a Service Module is
connected using a RS-232 cable.
Open Plus IQ. From the System drop-down menu, select Properties. See
Figure 8-29 Selecting Properties from the System Drop-Down Menu
NOTE: You must be in Advanced User Mode to set up communications. See
Section 8.9, Access Levels, on page 8-23
.
In case the COM port communication has been removed, select the Add Port
button. See
Figure 8-30
.
Figure 8-30 Port Settings in System Properties Window