INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 356)

10 - 10
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
10.2.1 Method Files
Method files are created using the HAPSITE Plus IQ software to direct the
instrument how to collect and analyze samples. Once created and saved, a Method
file can be selected to run samples. Method files are created and saved using the
Method Editor, to either a folder on the Laptop or the HAPSITE hard drive.
After method parameter changes are entered, the method needs to be saved.
When ready to save the method, press the Save button at the bottom of the Method
Editor window and the dialog window below is displayed. Notice that the default
location to save a method file is to the HAPSITE. Method files may be saved to the
Laptop hard drive in a manner similar to the way they are saved to the HAPSITE.
To save Method files to the Laptop, select the PC option as shown below in Figure
10-12 .
Figure 10-12 Save Method File Dialog Window - PC Option Selected
Selecting a different Laptop disk drive is achieved by clicking on the drive drop
down box. (
Figure 10-12 shows Local Disk (C:) selected.) To change folders on a
drive and choose from a list of available hard drives, move up using the Up One
Level button (shown in
Figure 10-13 ), or by double-clicking on an entry in the main
file list. New folders may be created by selecting the New Folder button.
Figure 10-13 Up One Level Button