INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 258
7 - 16
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Mass Cal.. . . . . . . . . . . . . . . . . . . . . Checks and corrects the ten calibration
masses for correct location within the mass
range.
Full Scan . . . . . . . . . . . . . . . . . . . . . Switches between Full Scan display mode
and Peak Scan display mode
Short AutoTune . . . . . . . . . . . . . . . Starts the Short AutoTune function
Long AutoTune . . . . . . . . . . . . . . . . Starts the Long AutoTune function
Noise Check . . . . . . . . . . . . . . . . . . Scans a "quiet" mass range (no peaks) to
determine the electronic baseline and
threshold noise level.
Tune Checkup. . . . . . . . . . . . . . . . . Runs a mass calibration and noise check.
Zoom . . . . . . . . . . . . . . . . . . . . . . . . Enables the cursor to select a section of Full
scan or a peak scan and zoom to that
section.
Mass Adjust . . . . . . . . . . . . . . . . . . Enables the cursor to select a mass peak
and drag the mass peak to a different
position on the mass axis.