8 detaching the hapsite, 1 using plus iq software to detach, Section 15.8, detaching the hapsite – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 491: To det, Ch the hapsite. see, Section 15.8, detaching, Figure 15-22
15 - 17
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Figure 15-22 Service Model Attached
15.8 Detaching the HAPSITE
Detaching the HAPSITE allows the safe removal of the HAPSITE from the Service
Module. The Detach procedure ensures that the interconnect plug on the HAPSITE
is closed at the proper time, and the two pumps in the Service Module are properly
shut down.
The detach procedure can be carried out either using Plus IQ software, or using
the HAPSITE front panel display.
15.8.1 Using Plus IQ Software to Detach
1
Be sure to connect the HAPSITE to the Laptop using a crossover cable before
continuing. Refer to
section 2.4.6, Connect Laptop (if desired), on page 2-10
a connection needs to be made.
2
In Plus IQ, left-click on the HAPSITE sensor to detach, then double-click the
Service Module icon, shown below in
Figure 15-23
.
Figure 15-23 Service Module Icon