INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 59)

2 - 21
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Figure 2-31 Power Cable Attached at Back Left of the Service Module
The RS-232 communication cable is shown in Figure 2-32 .
Figure 2-32 RS-232 Communication Cable
To prepare the Service Module for use with the HAPSITE, the aluminum plug must
be removed. If the plug is not under vacuum, the plug can easily be removed. If
under vacuum, the plug will need to be removed using the following procedure:
NOTE: The Service Module is shipped under vacuum from the factory with this
plug in place.
Attach the RS-232 communications cable to the Service Module, as shown in
Figure 2-33 .