INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 297)

8 - 21
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
When Add Port is selected, the window shown in Figure 8-31 will appear. Select
the appropriate COM port to add. Select COM1 or the appropriate COM port.
Figure 8-31 Selecting a COM Port to Add
After the COM port has been selected, the COM port will appear in the Port list in
the System Properties window, as shown in
Figure 8-32 .
Figure 8-32 Port List in Port Settings Tab of System Properties
Press the OK button. The system will automatically establish communications with
a Service Module (if powered on and connected using a RS-232 cable.) Please
refer to
Section 2.8.1, Setting Up the Service Module, on page 2-19 for more
details.