INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 53)

2 - 15
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
2.7.2 Installing the Headspace Sampling System
Required Parts
The following items are needed to install the HSS:
 Headspace instrument
 Y-cable power splitter
 Transfer line
 Carrier Gas
 Charged Battery
Procedure
1 Install a fully charged battery into the HAPSITE.
2 Unplug the AC to DC power converter power supply from the HAPSITE. See
Figure 2-21 .
Figure 2-21 Power Supply to HAPSITE from AC To DC Power Converter
3 Connect the single end of the Y-cable (see Figure 2-22 ) to the power supply
connector removed in step 2.
4 Plug one end of the Y-cable into the HAPSITE 24 V(dc) connector.
5 Plug the other end of the Y-cable into the back of the HSS. See Figure 2-22 .