Metrohm viva 1.1 (ProLab) - Manual (Page 133)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 121
NOTE
If a method is changed and saved in the method editor or during repro-
cessing, then the latest method version will be loaded when a new
determination is started.
NOTE
The following sample data fields can no longer be edited if they were
defined as Fixed value in the method (see Chapter 5.5.2.9.2.4, page
580).
ID1
Sample identification ID1. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 115).
Entry 100 characters
Selection Selection of text templates
ID2
Sample identification ID2. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 115).
Entry 100 characters
Selection Selection of text templates
ID3
Sample identification ID3. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 115).
Entry 100 characters
Selection Selection of text templates