Metrohm viva 1.1 (ProLab) - Manual (Page 529)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 517
End wavelength
Upper limit of the spectrum.
Input range 100.0 - 2,000.0 nm
Default value 1,000.0 nm
5.5.2.7.4 MEAS Opt
5.5.2.7.4.1 MEAS Opt - Overview
Dialog window: Method ▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command
name'
Command for absorbance measurements.
Instruments
This command can be executed with the following instruments:
Spectrometer: Avantes
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS Opt command are set on the following
tabs:
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for absorbance measurements.
￭ Additional measured values
Definition of additional measured values which can be saved as addi-
tional columns in the measuring point list.
Command variables
The following command variables are generated by the command MEAS
Opt in the method run and can be used in formulas under the designation
'Command name.Variable identification':