Metrohm viva 1.1 (ProLab) - Manual (Page 692)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
680 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
5.6.6.4 Define decimal places
Dialog window: Method ▶ Evaluation ▶ Results ▶ Results ▶ Edit ▶ Define decimal
places
NOTE
Calculations are made in the software with SI units and derived SI units
(see Chapter 5.6.7.1, page 695). Numerical values are shown in the
display and in the reports with decimal prefixes in order to avoid num-
bers with many decimal places. By selecting #, the prefix for the unit is
selected automatically in such a way that a number between 1 and 999
results for the integer value.
Peak potential
Number of decimal places for the peak potential (V).
Input range 0 - 6
Default value 3
Height
Number of decimal places and prefix selection for the peak height (A).
Input range 0 - 6
Default value 2
Selection # | m | µ | n | p
Default value #
RSD of the heights of all replications
Number of decimal places for the relative standard deviation of the peak
heights of all replications for the variation X (%).
Input range 0 - 6
Default value 1
Area
Number of decimal places and prefix selection for the peak area (C).
Input range 0 - 6
Default value 2
Selection # | m | µ | n | p
Default value #
RSD of the areas of all replications
Number of decimal places for the relative standard deviation of the peak
areas of all replications for the variation X (%).