Metrohm viva 1.1 (ProLab) - Manual (Page 401)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 389
Method comment
Comment on the method entered as (see Chapter 5.2.4.2.9, page 387) in
the START command.
Saving a method
Method name
Entry of the name under which the method is to be saved.
Entry 50 characters
NOTE
The method name must be unique in the entire client/server system.
[Save]
Save the focused method under the desired method name in the selected
method group.
The method check is automatically carried out before saving the
method; it can also be started manually at any time (see Chapter 5.2.5,
page 387). The method is checked as thoroughly as possible. Checks for
devices, sensors, solutions and dosing units are not carried out until the
start of the method in order to ensure that method commands can also
be created for devices which are not yet configured in the system. If an
error is detected during the method check, a message is displayed asking
whether the method should be saved nevertheless. Faulty methods cannot
be started.
A new method version with a new method identification is created each
time a modified method is saved (see Chapter 5.3.10, page 395).
5.2.7 Printing a method report
Menu item: Method ▶ File ▶ Print (PDF)...
The File ▶ Print (PDF)... menu item or the symbol can be used to
open the Print method reports (PDF) window, where the desired
report for the focused method can be selected and output as a PDF file.
Report selection
Select the content of the method report.
Selection Method sequence | Method parameters | Mea-
suring parameters | Evaluation parameters
Default value Method sequence