Metrohm viva 1.1 (ProLab) - Manual (Page 668)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
656 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
Active
Display as to whether the evaluation for this substance is active or not
active.
Potential step
Selection of the potential steps (plating potential and stripping potentials)
defined in the CPVS command (see Chapter 5.5.2.11.3.4, page 636).
Characteristic potential
Verification potential for the assignment of a peak to a substance.
VA measuring command = CVS:
Substance
Name of the substance.
Active
Display as to whether the evaluation for this substance is active or not
active.
Characteristic potential
Verification potential for the assignment of a peak to a substance.
Tolerance
Tolerance of the characteristic potential for the assignment of a peak to a
substance.
Min. width
Minimum peak width for the assignment of a peak to a substance.
Max. width
Maximum peak width for the assignment of a peak to a substance.
Min. measured quantity
Minimum measured quantity for the assignment of a peak to a substance.
Sweep direction
Shows whether the substance is to be evaluated during forward or reverse
movement of the cyclical sweep.
Modifies the sequence of shown substances by moving the selected line
upward.