7 properties - analog outputs, Properties - analog outputs – Metrohm viva 1.1 (ProLab) User Manual
Page 930
7.10 IO controller
■■■■■■■■■■■■■■■■■■■■■■
918
■■■■■■■■
viva 1.1 (for process analysis)
NOTE
With the aid of the following parameters the physical values that are
applied to the analog input can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Measured value to be used when the Low level (0 %) is applied as input
value.
Input range
-214,783,648.000 - 214,783,647.000
Default value
0
100% Mapping
Measured value to be used when the High level (100 %) is applied as
input value.
Input range
-214,783,648.000 - 214,783,647.000
Default value
100
Unit
Unit of the measured value to be used.
Entry
50 characters
Default value
%
7.10.7
Properties - Analog outputs
All recognized outputs are automatically listed in a table on the Analog
outputs tab. The settings can be modified for each analog output.
Port
Shows the internal designation of the port.
Port description
Shows the port designation.
Port specification
Shows the port specification.
Type
Shows the port type.
Low level (0 %)
Shows the lowest analog output value with unit.