Metrohm viva 1.1 (ProLab) - Manual (Page 577)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1 (for process analysis)
￭￭￭￭￭￭￭￭ 565
5.5.2.8.5.2 ANALOG IN - General
Tab: Method ▶ ANALOG IN ▶ Properties... ▶ ANALOG IN - 'Command
name' ▶ General
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the instrument type.
Selection IO Controller
Default value IO Controller
5.5.2.8.5.3 ANALOG IN - Stop criteria
Tab: Method ▶ ANALOG IN ▶ Properties... ▶ ANALOG IN - 'Command
name' ▶ Stop criteria
Command name
Name of the command.
Entry 25 characters
Stop criteria
Definition of possible stop criteria. The stop criterion that is reached first
leads to the cancellation of the command.
Maximum run time
on | off (Default value: off)
Check box for activation/deactivation of the stop criterion Maximum run
time. The command is canceled when the maximum run time has been
reached.