Metrohm viva 1.1 (ProLab) - Manual (Page 574)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
562 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the instrument type.
Selection IO Controller
Default value IO Controller
5.5.2.8.4.3 ANALOG OUT - Analog outputs
Tab: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Command
name' ▶ Analog outputs
Command name
Name of the command.
Entry 25 characters
Table
One analog output is parameterized in each line of the Analog outputs
table. The calculated or fixed value is written directly to the selected ana-
log output during the run.
One port can not be used more than once within a command.
If a command originates from a different instrument, the Port descrip-
tion of which does not exist on the currently selected instrument, then
the affected lines will be displayed in red lettering.
Functions
Moves the selected line up.
Moves the selected line down.
[New]
Opens the Analog output # dialog window in order to edit a new line
(see Chapter 5.5.2.8.4.4, page 563).
[Properties]
Opens the Analog output # dialog window in order to edit the selected
line (see Chapter 5.5.2.8.4.4, page 563).
[Delete]
Deletes the selected line.