Metrohm viva 1.1 (ProLab) - Manual (Page 610)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
598 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
In the case of Repeat loops, the loop command stands at the end of the
loop. If a stop criterion is fulfilled (Case 2), then the next command after
the loop command is executed. If no stop criterion is fulfilled (Case 1),
then the loop is carried out once more. The loop is thus run through at
least once in any case.
In the case of While loops, the loop command stands at the beginning
of the loop. If the loop arrow is dragged on a command under the loop
command, then an arrow back to the loop command is created automati-
cally from the previous command. If a stop criterion is fulfilled (Case 2),